Your furnace runs for two minutes, shuts off, then starts again. Or the thermostat says 72 but the house still feels cold. Before you assume you need furnace repair in San Antonio, check the thermostat. At So Tex Indoor Air Comfort, many fall calls turn out to be a thermostat misreading the room, set wrong, or losing power — not a failed furnace.
The 1-to-2 Degree Thermometer Test
Place a room thermometer next to your thermostat for 15 minutes, away from lamps, TVs, and direct sun. If it disagrees by more than 2 degrees, your thermostat is likely out of calibration. Reading warm, it shuts the furnace off early and leaves rooms cold. Reading cold, it runs past the set point and raises your bill. Dust, a mount on a drafty exterior wall, or a spot above a heat source can all throw it off. Wipe dust gently first. If the gap stays, call for HVAC service in San Antonio to test, recalibrate, or replace it.
Check Heat, Auto, and Batteries First
Make sure the system is set to Heat, not Cool or Off, and the fan is on Auto, not On. On On, the blower pushes unheated air between cycles, which feels like cold air from the vents. Replace the batteries if your model uses them — weak batteries cause blank screens, lost schedules, and shutdowns that look like a furnace failure. Confirm the set temperature is at least 3 degrees above room temperature, or it will not call for heat.
Short Cycling: When the Thermostat Is the Trigger
Short cycling — starts and stops every few minutes — wears out ignitors, blowers, and controls, and is a common reason for heating repair in San Antonio. A thermostat can cause it if it sits near a supply vent, in direct sun, or in a draft. A failing sensor or loose wiring can too. But it is not always the thermostat: a clogged filter, an overheating furnace tripping its limit switch, or an oversized system from a past heater installation in San Antonio looks identical. If the filter is clean and the thermostat checks out, do not keep resetting it — get a diagnosis.
Smart Thermostats and What an Upgrade Fixes
A modern smart thermostat holds calibration better and can flag sudden run-time changes — an early warning something is off. Every new system installation in San Antonio from So Tex includes a Sensi Lite smart thermostat in the flat-rate total, along with the city permit and an installed media filter, with all model numbers in writing. If yours is over 10 years old or cannot hold a program, upgrading beats repeat calls. We use the same approach for AC repair in San Antonio — verify the control first, then the equipment.
When to Call a Professional
Call if the screen stays blank after new batteries, you see loose or damaged wires, the reading is still off by more than 2 degrees after cleaning, the furnace short-cycles with a clean filter, or you smell gas or burning. Do not open the furnace cabinet or move thermostat wiring yourself.
If you are not sure whether it is your thermostat or your furnace, call So Tex Indoor Air Comfort at (210) 306-4205 for same-day service during business hours. We will test the thermostat, check calibration, and give you one clear answer and a flat-rate price if a repair is needed. TX HVAC license #TACLB78723E.

Leave a Reply