If you are price shopping a new system, tonnage is only the starting point. Two quotes for the same 4-ton system can be thousands apart because one includes the permit, thermostat, and filter base and the other adds them later. At So Tex Indoor Air Comfort, we give one flat-rate total for system installation in San Antonio before work begins — no surprise add-ons.
So Tex Standard Prices by Tonnage
Our SoTex Comfort Fall Special Standard tier is a single-stage system priced by size: 2-ton $7,936.92, 3-ton $8,498.46, 4-ton $9,161.76, and 5-ton $9,685.29. That price includes a basic thermostat, a basic filter base in case your home needs one, the city permit, and a 10-year parts warranty. Our new Goodman and Liberty systems use R-32 refrigerant — not R-454B — in matched indoor and outdoor equipment.
Those are real starting prices for the Standard tier, not an outdoor unit alone. A 3-1/2-ton system is not on this ladder — whole tons only — and is priced on its own. Every home still gets an in-person verify visit before the final price is locked in, because duct condition, electrical, and access can change what a job needs.
Why Tonnage Alone Does Not Set the Price
Tonnage measures capacity, not comfort by itself. Too small, and the system runs all day and never catches up. Too big, and it short-cycles, leaves humidity behind, and wears out sooner. That is why we size with a room-by-room heat load per ACCA Manual J using AirMatch, not by copying the old unit.
Fuel type matters too. Gas furnace, straight-cool, and heat pump systems use different indoor equipment, and that changes the total. When we handle heating repair in San Antonio homes, we often find the old system was never sized right — replacing like-for-like just repeats the problem.
What Some Quotes Leave Out
Ask any company to put these in writing: city permit, thermostat, filter base or media filter, disconnect and pad if needed, and warranty terms. Some low quotes cover the boxes only, with permit fees and duct changes added on install day. Others sell on a federal tax credit that has already ended.
So Tex handles CPS Energy rebate paperwork for qualifying systems. CPS pays up to $310 per ton depending on SEER2 rating, as an “up to” amount back to you — it does not change your flat-rate total. Inside San Antonio city limits, the application needs your permit number, one more reason the permit belongs in the quote from the start.
Repair First, or Replace?
If your current system still runs and the repair is minor, honest HVAC service in San Antonio starts with the repair price — in writing, before work begins. Replacement makes more sense when the system is at the end of its life, needs a major part like a compressor, uses an older refrigerant that keeps getting more expensive to service, or has needed furnace repair in San Antonio more than once in the last two winters.
Ask for both numbers side by side: the flat repair total today, and the flat replacement total by tonnage. That comparison is how San Antonio homeowners decide without pressure.
Get Your Exact Flat-Rate Price
Use the ladder above to budget, then let us verify your home, your ducts, and the right size before you sign anything. So Tex Indoor Air Comfort provides system installation in San Antonio and heating repair in San Antonio with same-day service during business hours when available. Call (210) 306-4205 to schedule your verify visit today. TX HVAC license #TACLB78723E.

Leave a Reply