San Antonio can drop from 85 degrees to the 50s the same night, and that first switch from cooling to heating is when heaters fail. Your furnace or heat pump sat idle for months collecting dust, so just flipping to Heat is risky. Do these checks first to catch small problems before you need urgent heating repair San Antonio homeowners dread on a cold morning.
1. Clear the Furnace Area and Change the Filter
Clear anything stored tight against the furnace or air handler — it needs space to operate safely. Then pull the filter. After a long cooling season it is loaded with dust, and a clogged filter causes short cycling, weak airflow, and overheating. Replace it with the correct size, arrow toward the system, date the frame, and check monthly through cedar season.
2. Switch the Thermostat the Right Way
Move the thermostat from Cool to Off, wait a few minutes, then set Heat with the fan on Auto, not On. Fan On blows unheated air between cycles and makes a working heater feel broken. Set it 3 to 4 degrees above room temperature for the first test. You should feel warm air within minutes. For heat pumps, a brief cool puff and steam in defrost can be normal. Constant cold air, clicking with no ignition, or repeated cycling is not — call for furnace repair San Antonio service.
3. Expect the First-Burn Smell — and Know the Warning Smells
A dusty burnt smell for the first few hours is normal — dust on the burners or heat strips burns off at first fire-up. Turn it off and call right away for rotten eggs or gas, burning plastic, wiring, or rubber, strong smoky exhaust, or an odor still strong after a day. Carbon monoxide has no smell, so never use your nose as the safety test. Those smells can mean a gas leak, electrical fault, or venting problem needing professional HVAC service San Antonio right away.
4. Test Smoke and Carbon Monoxide Detectors
Press the test button on every smoke and CO detector the day you switch over, replace weak batteries, and check the date — CO detectors expire in 5 to 10 years. Homes with a gas furnace, gas water heater, or attached garage need CO detectors outside sleeping areas. If one sounds, get everyone outside, call 911, then call for heating repair. Do not reset it and run the heater again.
5. Run It Early and Book the Tune-Up Before the Cold Front
Test heat on a mild afternoon, not at 6 a.m. in the first freeze, so you can schedule a fix on your terms. A fall tune-up — So Tex’s $79 So Tex Revive — tests the igniter and flame sensor, inspects the heat exchanger, checks gas and venting, verifies safety switches, and confirms thermostat accuracy. Heat pumps need it twice a year because they work both seasons.
If your switch-over test turned up cold air, strange noises, warning smells, or a system that will not start, do not keep cycling it. Call So Tex Indoor Air Comfort at (210) 306-4205 for HVAC service San Antonio, heating repair San Antonio, furnace repair San Antonio, and heater installation San Antonio — plus AC repair San Antonio and full system installation San Antonio — under TX HVAC license #TACLB78723E. We offer same-day service during business hours, Mon–Fri 8 AM–8 PM and Sat 9 AM–1 PM, with a written flat-rate total before any work starts.

Leave a Reply