If a neighbor says they have “electric heat,” that could mean two very different systems — and two very different winter bills. One uses resistance strips, like a giant toaster inside your air handler. The other is a heat pump, which is also electric but works in a completely different way. That mix-up shocks homeowners with January bills.
Resistance Strips: Simple, Hot, and Expensive to Run
Resistance heat makes heat directly. Power runs through metal strips, the strips glow hot, and your blower pushes air across them. It is simple and common in homes with no gas line. The catch is efficiency: for every unit of electricity you buy, you get about one unit of heat — never more. For a mild night it is fine, but in a freeze your meter spins. Very hot vent air plus a jumping bill often means strips are doing most of the work — a common reason for a heating repair San Antonio call.
A Heat Pump: Also Electric, But It Moves Heat Instead
A heat pump does not create heat from electricity. It moves heat already in outdoor air into your home, using refrigerant — the same system that cools you in summer, in reverse. Because it moves heat instead of making it, it can deliver two to three times more heat per unit of electricity than strips on a typical San Antonio winter day. Vent air feels cooler, around 90 to 100 degrees, but it is steady and much cheaper to run. New heat pumps at So Tex Indoor Air Comfort use R-32.
Where a Gas Furnace Fits In
A gas furnace burns natural gas and delivers the hottest supply air, around 120 to 125 degrees, so rooms warm fast in a freeze. With a gas line, a furnace is often the lowest-cost heat on the coldest days, and furnace repair in San Antonio is familiar work — igniters, flame sensors, and burners. Trade-offs: a gas connection and carbon monoxide monitoring. See also our heating repair service in Boerne. No single winner — only the right fit for your home.
Why Your Bill Tells You Which One You Have
Watch the first really cold night. If your bill spikes, strips are likely running long — either as your only heat, or as a heat pump’s overused backup. A dirty filter, defrost problem, or EM Heat setting can push it onto strips early. EM Heat turns the heat pump off entirely and runs strips only — use it only if the heat pump is broken. Professional HVAC service in San Antonio checks staging and settings before winter, so cheap heat runs first.
Which One Fits Your San Antonio Home?
No gas line? A high-efficiency heat pump usually beats strips alone on operating cost, and may qualify for a CPS Energy rebate. Gas line in place and you love fast, hot air? A gas furnace, or a dual-fuel pairing, may fit best. Strips as your only heat and bills that hurt every freeze? Talk about a heat pump before your next heater installation in San Antonio. We measure first and give one flat-rate total in writing before any system installation in San Antonio begins.
Confused by your bill or your “electric heat”? Call So Tex Indoor Air Comfort at (210) 306-4205 for heating repair, furnace repair, and heater installation in San Antonio. Same-day service during business hours, Mon–Fri 8 AM–8 PM, Sat 9 AM–1 PM. TX HVAC license #TACLB78723E.

Leave a Reply