Your Furnace Clicks but Won’t Light — or Lights and Dies in Seconds? Read the Ignition Sequence

You turn the thermostat up, hear click, click, click — and no heat. Or the burners light, run five seconds, and shut off. In San Antonio, that pattern shows up on the first cold nights every fall, and it points to one step in the ignition sequence. So Tex Indoor Air Comfort sees the same three culprits — igniter, flame sensor, and control board — on most of these calls.

A modern furnace proves each step is safe first — the symptom tells you where it stopped.

The Ignition Sequence, Step by Step

First, the thermostat calls for heat and the inducer motor starts, clearing the vent. A pressure switch proves that draft — if the vent is blocked or the switch fails, the furnace stops there, with no glow and no flame.

Next, the hot surface igniter glows bright orange. The gas valve opens, the burners light, and the flame sensor — a thin rod in the flame — proves fire is really there. Only then does the blower move warm air. When you need HVAC service in San Antonio, that sequence is the map we follow first.

Clicks, but No Glow and No Flame

Clicking with no glow usually means the igniter never got hot, or it cracked and failed. Igniters are fragile ceramic parts that last three to seven years, and they often fail after sitting all summer. It can also mean the board is not sending voltage, or the pressure switch never proved draft.

Do not keep resetting the furnace. After about three failed tries, most systems lock out and flash a blink code on the board, visible through the sight glass. Note that code — it helps a technician bring the right part. This is furnace repair in San Antonio work, not a filter change.

It Lights, Then Dies in Seconds

If the burners light and die immediately, suspect a dirty flame sensor first. The rod builds up a coating, and once it cannot sense flame cleanly, the board shuts the gas off — exactly as designed — even though the flame was fine.

Cleaning the rod often restores it — a common first-fire-up repair. If it does not hold, the sensor, valve, or board needs meter testing. Homeowners nearby get the same diagnosis through our heating repair service in Boerne.

The Safe Checks You Can Do Yourself

Check four things: the thermostat is set to Heat and above room temperature, the furnace switch and breaker are on, the filter is clean — a clogged filter causes its own shutdowns — and the gas shutoff has not been bumped off.

Stop there. Do not open the burner compartment or bypass a switch. If you smell gas, hear the CO alarm, or see soot, turn the system off and call for help. Gas and ignition parts are a licensed technician’s job.

When to Call So Tex — and What Happens Next

Call when the furnace clicks without lighting, lights and dies repeatedly, locks out, or leaves the house cold on a freeze night. So Tex Indoor Air Comfort provides flat-rate heating repair in San Antonio, with the price in writing before work starts, and we inspect the heat exchanger on gas repairs.

Most igniter and sensor repairs finish in one visit, parts on the truck.

So Tex Indoor Air Comfort — furnace repair San Antonio, heater installation San Antonio, and AC repair San Antonio. TX HVAC license #TACLB78723E. Call (210) 306-4205 for same-day service during business hours — Monday through Friday 8 AM to 8 PM, Saturday 9 AM to 1 PM.

Leave a Reply